Thingiverse
Khadas Tone 1 Housing
von NimMM
0
Downloads
1
Likes
0
Makes
A basic box to house the Khadas tone 1 while I wait on a metal enclosure:
- Uses m2 screws for mounting. 4-6mm in length should do.
- Uses 5mm M2 stand-offs for the PCB
- the bottom is attached by way of heat-setting m2 knurled stand-offs that are ~3mm OD as I don't have actual heat-inserts on hand in M2. 5-8mm long ones should do
- Should basically print in any filament, it's just a simple box
Depending on how chunky your RCA connectors are, it might tip over a bit.
Note: Use the 3MF files if you can, the STLs are just there to keep Thingiverse happy
- Uses m2 screws for mounting. 4-6mm in length should do.
- Uses 5mm M2 stand-offs for the PCB
- the bottom is attached by way of heat-setting m2 knurled stand-offs that are ~3mm OD as I don't have actual heat-inserts on hand in M2. 5-8mm long ones should do
- Should basically print in any filament, it's just a simple box
Depending on how chunky your RCA connectors are, it might tip over a bit.
Note: Use the 3MF files if you can, the STLs are just there to keep Thingiverse happy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
