Kickdown Door Stop Recessed Receiver

This is a receiver for a kickdown door stop. I needed a method to stop the door about ~60 degrees. So I installed the door stop, and then designed this to be drilled into the floor. This design uses a screw in sleeve which can be removed and replaced with a solid top one that would eliminate the door stop or allow you to modify the design in case you get a different size door stop. Installation:Install the Kickdown door stop on the door, remove the rubber tip, and install the pin coverMark the location of the receiver based on the door stop Drill a ¼" (~6mm) deep using a 1 1/8" (1.125") forstner drill bitInsert drill guideDrill a 1" through hole (drill guide is designed for a 1" forstner drill bit)Glue in bodyThread in the receiver sleeveItems used:Kickdown door stop - AmazonForstner drill bits - Amazon