Thingiverse
Kid's toy lock
von Gophergames
23
Downloads
20
Likes
0
Makes
I designed this toy padlock for my little daughter. It should work with any standard key, or anything else that will fit.
You will need a spring that is about 17 mm by 6 mm for the lock to operate. You can also stick a pen spring in the bottom of the latching piece so that it springs up when the lock is turned.
You will need a spring that is about 17 mm by 6 mm for the lock to operate. You can also stick a pen spring in the bottom of the latching piece so that it springs up when the lock is turned.
Gophergames veröffentlicht auch auf
36 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
