Kill Team Tournament Tray
di wzzzrd
31
Download
27
Likes
0
Makes
I made this Kill Team tournament tray to fit inside my 8x8.5 inch battlefoam bag, the tray is designed to keep my dice, cards, tokens and other bits as well as miniatures.
**Bases**
12x 32 or 25 mm base slots
2x 40, 32, or 25 mm base slots
**Card Section**
The section that holds your KT cards has a raised center section so that it is easier to pull up your cards and you don't have to dig down under the cards to pull them up.
**Printing Suggestions**
If you are confident with bed adhesion this will print just fine, in roughly 240 grams with my print settings. If you have issues with bed adhesion I would suggest a brim (I used a 5 perimeter brim)
**Bases**
12x 32 or 25 mm base slots
2x 40, 32, or 25 mm base slots
**Card Section**
The section that holds your KT cards has a raised center section so that it is easier to pull up your cards and you don't have to dig down under the cards to pull them up.
**Printing Suggestions**
If you are confident with bed adhesion this will print just fine, in roughly 240 grams with my print settings. If you have issues with bed adhesion I would suggest a brim (I used a 5 perimeter brim)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
