Thingiverse
KIM-1 Keypad
por HackUp
3
Descargas
2
Likes
0
Makes
This is a keypad case that I made for the [KIM-1 replica](https://www.forum64.de/index.php?thread/124855-instandsetzung-und-nachbau-eines-kim-1/) created by user ralf02 on forum64.de.
**Warning: Still work in progress and subject to change!**
In addition to the printable components you'll need the following:
* 2 keypads with 16 keys each as shown (actually, you just need 1 1/2)
* 1 keypad PCB (not yet released)
* 1 SPDT slide switch, 2.54mm pitch
* 1 female pin header connector, 15 pins, preferably low profile
* 1 male pin header, 15 pins to match the female one
* 6 self tapping screws, 2x6mm
* labels printed white on black for the keys E, F, AD, DA, PC, +, GO, ST, RS
* double sided adhesive tape to glue the clips to the motherboard
The printable feet included here are not for the keypad but for the KIM-1 motherboard itself. You'll need M3 nuts and short screws for these.
**Warning: Still work in progress and subject to change!**
In addition to the printable components you'll need the following:
* 2 keypads with 16 keys each as shown (actually, you just need 1 1/2)
* 1 keypad PCB (not yet released)
* 1 SPDT slide switch, 2.54mm pitch
* 1 female pin header connector, 15 pins, preferably low profile
* 1 male pin header, 15 pins to match the female one
* 6 self tapping screws, 2x6mm
* labels printed white on black for the keys E, F, AD, DA, PC, +, GO, ST, RS
* double sided adhesive tape to glue the clips to the motherboard
The printable feet included here are not for the keypad but for the KIM-1 motherboard itself. You'll need M3 nuts and short screws for these.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!