Thingiverse
Kindle Paperwhite protective case
von dugacki
89
Downloads
89
Likes
0
Makes
Kindle paperwhite case with a simple graphic design.
- Printed with PLA - it will probably work with any rigid material.
- You can orient Kindle in any 4 directions
- Optimised for a 0,5mm nozzle size: 1,05mm wall thickness (two perimeters).
- Also included a file optimised for mor common 0,4mm nozzle (0,85mm wall) but I haven't printed it yet.
- Depends on your printer/settings the fit can be just right or a little bit loose. Put some masking tape on the inside, if the fit is too loose, you don't want the device freely sliding out.
Enjoy
- Printed with PLA - it will probably work with any rigid material.
- You can orient Kindle in any 4 directions
- Optimised for a 0,5mm nozzle size: 1,05mm wall thickness (two perimeters).
- Also included a file optimised for mor common 0,4mm nozzle (0,85mm wall) but I haven't printed it yet.
- Depends on your printer/settings the fit can be just right or a little bit loose. Put some masking tape on the inside, if the fit is too loose, you don't want the device freely sliding out.
Enjoy
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
