Kinect Grip and Tripod Mount

When I saw tokagehideto's handle grip for the Kinect I thought it was almost perfect. I have been wanting to use the Kinect V1 both handheld and on a tripod so I just added the piece in the front. The added length doesn't seem to get into the way when the scanner is level to the base. Adding the nut to mount it to the tripod is a little tricky, I didn't want it to be visiable from the top so you have to add the 1/4 nut during the printing process. The nut location starts to close at 9.7mm from the print bed so you have to watch closely. The nut I used was about 5.6mm high and 10.96mm from flat edge to flat edge.

Thanks tokagehideto for the original grip.

I'm not very good with 3D CAD yet so the part might be seperate from the handle. If the part is seperate, in Cura or whatever print software you use,just put the part into the handle a little ways and it will print as one piece.