Kinematic frame with Snap Fit

Summary Kinematic frames that snaps together. A standard frame as well as an axis angle version can be printed. The XYZ-axes will fit both the 'origo' and the 'axis_origo'. Notes: The x, y, and z axis can all be printed without support. The origo should have support for the floating snap fit pins. Support might be generated for the logo, but can be blocked. When using the frame it is recommended to glue the x-axis to the origo as it is the most fragile because it is printed perpendicular to the layer lines. It also makes it harder to lose the origo piece. If you decide to print the axis origo make sure to only allow support on the bottom of the sphere, and block all the support going in the channels, as this alleviates a lot of hassle. Its a good idea to set the support threshold to 55 degrees, and then block all support not going on the bottom. After slicing, the support should look like the last picture seen above.