Thingiverse
king and Queen (chess)
von wilburn_prints
0
Downloads
0
Likes
0
Makes
This is the king and Queen from a chesset I'm designing. check out my other pieces once I uploaded them shortly.
I used 1.75mm HS PLA, 0.4mm nozzle. Make sure you get rid of any surplus filament on king's cross. Enjoy!
I used 1.75mm HS PLA, 0.4mm nozzle. Make sure you get rid of any surplus filament on king's cross. Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
