Thingiverse
KingKong 90GT Camera Mount
por patshead
13
Descargas
8
Likes
0
Makes
This is a bracket to mount a small 200mw VTX camera on a KingKong 90GT micro drone.
I knocked out a quick design before the camera arrived--I wanted to get it back in the air ASAP. I didn't realize the seven segment LED would be sticking out so far in the back, so I had to take a set of snips to the mount to get the camera to sit flush.
It works, and the rubber bands do a fantastic job of keeping the camera in place. They also allow the camera to get knocked over in a hard crash. I'm hoping that will help keep the antenna from getting too banged up or bent.
I plan to reshape the mount to fit better, but I figured I'd upload it now since it already works with a little modification!
I knocked out a quick design before the camera arrived--I wanted to get it back in the air ASAP. I didn't realize the seven segment LED would be sticking out so far in the back, so I had to take a set of snips to the mount to get the camera to sit flush.
It works, and the rubber bands do a fantastic job of keeping the camera in place. They also allow the camera to get knocked over in a hard crash. I'm hoping that will help keep the antenna from getting too banged up or bent.
I plan to reshape the mount to fit better, but I figured I'd upload it now since it already works with a little modification!
patshead también publica en
51 modelos adicionales en 2 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
