Thingiverse
Kingroon_KP3S_Spool_Holder
von j-design
128
Downloads
118
Likes
2
Makes
This is the filament Spool-Holder for KP3S.
It can also be used as a extensive use.
608zz bearing (1EA) for securing Lead-Screw,
6905zz bearings (2EA) are required inside the Spool-Holder.
Please correct the vertical of the lead screw by referring to the attached photo.
CAUTION: Remove the 608zz bearing if it is difficult to straighten the Lead-Screw. It won't have a big impact on the print.
It can also be used as a extensive use.
608zz bearing (1EA) for securing Lead-Screw,
6905zz bearings (2EA) are required inside the Spool-Holder.
Please correct the vertical of the lead screw by referring to the attached photo.
CAUTION: Remove the 608zz bearing if it is difficult to straighten the Lead-Screw. It won't have a big impact on the print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
