Thingiverse
kink protection
door Sebastian_97
2
Downloads
1
Likes
0
Makes
I always had the problem that the cables and the tube compressed at the top of the printer if I printed a mesh that was higher than around 15cm.
Also i removed the cable tie so the cables ar no longer kinked.
printed with the bigger hole on the bottom.
Also i removed the cable tie so the cables ar no longer kinked.
printed with the bigger hole on the bottom.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
