Kioti Tractor Cab Cup Holder Insert

The factory “cup holder” area in the Kioti tractors are made oversized, I'm assuming to accommodate large thermos bottles or to allow the driver to use it for something other than putting your beverage right next to you. Otherwise there is nowhere else to keep your beer can or Yeti Rambler. However, the size of the factory opening does not keep any beverage container snug. This cup holder insert was designed to fit within the factory cup holder of a Kioti NX4510 cab tractor, but may fit others if the opening in your tractor is around 111mm in diameter. I've counterbored two holes for mounting screws, and the center hole lines up to the factory drip hole in case of any spills or condensation to run off. I printed in PLA Basic (Light Gray) The counterbore area in the bottom of the print, for the two screw holes, is 11.5mm in diameter, to allow the use of a small washer or pan head screw. Boost MePlease help a fellow aspiring modeler and newbie to 3D printing. Boost Me!