Kirby Figurine.

Modeled this little guy while trying to improve my skills. All of it was basic shapes so it was a good practice. Some info about this print: Most parts are separate and some of them are small but I did them all without a brim, so make sure you have your filament well dried and plate clean. These parts are tight and I did not use any glue on mine, but if you want you can use some on the feet, in case the print falls down or something. One of the supports ended on the tip of the mouth so remove it carefully. That's it. Hope you like it. Don't forget to comment and rate. Thank you.Boost Me