Thingiverse
Kitchen led strip holder
von velimir97
29
Downloads
14
Likes
0
Makes
Led strip holder/mount.
The channel in the part is made so it nicely fits a standard IP65 rated led stip (with transparent silicone cover). It isn't necessary to glue the IP65 led stirp to the part.
The LEDs position in the mount is angled so they face away from peoples eyes.
Two lenghts available, one is 258cm which fills up most of my Ender 3 bed when positioned diagonally, other one is smaller at 180cm.
There are two M3 screwholes which are countersunk. I used 15mm wood screws to screw them in under my upper cabinets.
Additionally it should work with double sided tape since the weight is quite low, but I haven't tried that.
The channel in the part is made so it nicely fits a standard IP65 rated led stip (with transparent silicone cover). It isn't necessary to glue the IP65 led stirp to the part.
The LEDs position in the mount is angled so they face away from peoples eyes.
Two lenghts available, one is 258cm which fills up most of my Ender 3 bed when positioned diagonally, other one is smaller at 180cm.
There are two M3 screwholes which are countersunk. I used 15mm wood screws to screw them in under my upper cabinets.
Additionally it should work with double sided tape since the weight is quite low, but I haven't tried that.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
