Thingiverse
Kitchen Sponge Holder
von Profkanz
6
Downloads
9
Likes
1
Makes
Not satisfied with the commercially available kitchen sink sponge holders that are too floppy and allow mold to grow, I designed this one to fit my sink and allow sponges to dry.
Printed in PETG on its side, as shown in one of the photos, with a brim to improve adhesion to the build plate.
Printed without supports at 20% infill, 3 perimeters and .2mm layer height.
Printed in PETG on its side, as shown in one of the photos, with a brim to improve adhesion to the build plate.
Printed without supports at 20% infill, 3 perimeters and .2mm layer height.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
