KitchenAid tool/attachments holder

This tool holder comes in three versions, one for large print beds, one for smaller ones and a single-holder version for when you want complete control over the placement. The wide gap between tool holders is needed so that various attachments wont bump into each other when stored.
The single holder is meant to be screwed into the side of a kitchen cabinet using self tapping wood screws while the large triple holder has enough surface area to allow for glueing it in place using either CA / Hot glue / Consturction adhesive.

(see pictures) the layer orientation means that the holder is unlikely to snap off and the whole thing can be printed as one with minimal supports

I recommend printing it solid with either PLA or PETG, both of these filaments are food safe but PETG also adheres better than PLA