Thingiverse
Kiteboard Wall Hanger
por maxme
36
Descargas
36
Likes
0
Makes
This is a simple design of a kiteboard wall hanger. I use it in my garage to store my board after rincing it.
Printed on an Ender 3, 0.28mm height, 20% filling.
I printed a smaller version (80%) it works fine.
Printed on an Ender 3, 0.28mm height, 20% filling.
I printed a smaller version (80%) it works fine.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
