Kitplanes Wingtip LED Strobe Light Upgrade

In May 2019 Kitplanes magazine is article "Two Flash or Not Two Flash" about upgrading Aeroflash wingtip strobe lights to LED writen by Chuck Deiterich. With his and Kitplanes permission here are some parts I had designed based on the article. Also I had made a similar parts for rear half sphere tail light.

Wingtip lights
- mold for silicone LEDs base with grooves for wiring

Tail light
- mold for silicone LEDs base with groves for wiring
- base for the light

Common
- housing for 5x7cm PCB (will upload a circuit drawing and silkscreen design
once verified) with connector openings for 3pin Molex
- fixture for soldering LED for proper wire length and bulbs position

8/17/20: Added 3 LED assembly files with assembly soldering fixture. The LEDs heatsinks need to be trimmed to fit in the mold. When trimming the alu heatsink using a file, most of them were damaged so I had use a snips only. Be sure to test the bulbs before assembly to be sure they're working properly.