Thingiverse
Kiwami Piercing Needle Holder
von joeltrondotcom
1
Downloads
1
Likes
0
Makes
Sick of your Kiwami needles flopping around the studio? This print may just be for you!
I prefer to usually print these with PETG on a texture sheet, top-face down, so you get a nice finish.
Available in a few versions:
├── Kiwami Stand 10deg tilt.stl
├── Kiwami Stand Straight.stl
├── Kiwami Stand All Large 10deg tilt.stl
├── Kiwami Stand All Large Straight.stl
├── Kiwami Stand All Small 10deg tilt.stl
├── Kiwami Stand All Small Straight.stl
I prefer to usually print these with PETG on a texture sheet, top-face down, so you get a nice finish.
Available in a few versions:
├── Kiwami Stand 10deg tilt.stl
├── Kiwami Stand Straight.stl
├── Kiwami Stand All Large 10deg tilt.stl
├── Kiwami Stand All Large Straight.stl
├── Kiwami Stand All Small 10deg tilt.stl
├── Kiwami Stand All Small Straight.stl
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
