KK2.0 Flight Control Board Case

Please not this will not fit the new kk-2.1 for sale at Hobbyking

A low profile and light weight case for the Hobbyking KK2.0 Multirotor flight controler.

I printed this on a UP! which deals with the overhangs on the lid
For other printers I am not sure if it will work ?

When testing the fit with a friends KK board I notice that the newer boards have a JST connector for the buzzer,mine had a servo conector.
We think the jst plug will still fit in the servo hole if you carefully swap the terminals so the plug will work upside down.
I may fix this later hence work in progress.


Some notes
the pins sit slightly proud with the top.
I'm not sure how well this will protect your board in a crash (i'm sure I will find out soon :-)
There are no holes in the base because I forgot to add them (I used sticky pads) i may fix this as well.
I used a single JWT conector and a single pcb header pin for the voltage conector
http://www.hobbyking.com/hobbyking/store/__29277__J