KK2 Flight Controller Case with Mounting tabs

A simple case for the KK2 multi rotor controller with mounting tabs. I'm going to make a version without the tabs as well, but that might take a few days since I'm a total noob at 3D drawing and it takes a while to get it the way I want :)

** UPDATE 12-29-2013 **

V1.0 of my KK2 casing is now available..

Added the requested slot for the voltage cable.
Reduced the size of the screw holes in the top of the casing and fixed a few other minor details I've discovered since printing V0.6

With the case "upgraded" to V1 this is no longer a "work in progress" and there will most likely not be any more changes to it.

No, there is no V0.7 - 0.9 :)

Enjoy, and happy flying..

** UPDATE 09-14-2013 **

V0.6 of my KK2 casing is now available..

I made some small adjustments to the buttons to accommodate the fact that the buttons on the KK2 aren't always perfectly aligned. I've made the holes 0.5mm wider, 0.4mm deeper and slightly tapered and now they should work with any KK2