Klask Biscuit

A Klask game biscuit with characteristics very close to the original one. Uses 4x1mm magnets.Notes on magnets3 magnes sizes supported:3x2: untested, but should be close to original (this is the original magnets size)4x1: tested, recommended (behaviour very close to original)5x1: tested, not recommended (magnets are stronger than the original ones)Print notesNo supports neededSet up a pause on the last layer before the magnet hole is getting closed, push the magnet in and then restart printingNote that the south pole of the magnet should be pointing towards the top! If in doubt, compare with the original magnetI played with settings to get the closest characteristics to the original and I recommend these: 1 top shell layer, 1 bottom shell layer, 1 wall loop, gyroid 56% infill If you have the original one for reference, compare it after the printing (if you have precise scales - by mass, but also by the distance from the striker magnet where it gets attached to it.Updates log2025-09-27: