Klicky-Probe for FBGH5 Lime Head

Hi!

Nice project, SimONtron. TNX!
I used some files from the official instructions https://github.com/jlas1/Klicky-Probe/tree/main/Probes/KlickyProbe
Probe Dock v2.1
KlickyProbe_Microswitch_XL-3
I didn't have 6x3 magnets, so you'll need the 5x2 ones I used. Or edit the models.

For KlickyProbe_Microswitch_XL-3_mount_5x2-magnet_LimeVolcano, you'll need M2.5 brass nuts and screws, respectively.

For KlickyProbe_Holder Probe Dock_FBGH5, M3 screws, washers, and nuts. The docking station is installed in the far right corner. Pay attention to the long outer plane. There's a small blind hole there. I wasn't sure I'd want to drill a hole in the side wall of the casing, so I did it just in case. Then I finally decided to do it, and it helped me make precise markings. I simply screwed the M3 into the plastic, it holds well enough.

Further !!!approximate!!! config variables;

printer.cfg
...
[probe]
x_offset = 41.0
y_offset = 0
z_offset = 3.18
...

klicky-variables.cfg
...

variable_docklocati