Thingiverse
KM LU-202 lock screw
by mlodawy
0
Downloads
0
Likes
0
Makes
Happened to snap in the middle few of them, so i came up with design very similar to original part. Its before any testing and i will add edit in the future how this design is working out in the field.
Hole is 0.3mm larger than screw barrel, but after first test with PET i was sure thats perfect to get it in with no tools with a little resistance, and I wasnt able to get it out without pliers. To make sure it stays in place i will be using acrylic glue.
Design might change depending on how important is rim around screw, if so it will be commented in EDIT section.
Hole is 0.3mm larger than screw barrel, but after first test with PET i was sure thats perfect to get it in with no tools with a little resistance, and I wasnt able to get it out without pliers. To make sure it stays in place i will be using acrylic glue.
Design might change depending on how important is rim around screw, if so it will be commented in EDIT section.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
