Thingiverse
Knife Handle
von KosArt
11
Downloads
15
Likes
0
Makes
I designed this knife handle last year and it proved useful again when I needed to make one for another knife.
It comes in 2 parts - left and right, which you fix in with screws and bolts. Then you cover the screws with the caps. If you print it in one color, the covers are almost unnoticeable.
Important! The screws can rust so I would advise to cover them in silicone or hot glue before putting the cap on.
You need to print 6 caps for the screws.
Best material is PETG or ABS, since PLA would deform over time under hot water.
It comes in 2 parts - left and right, which you fix in with screws and bolts. Then you cover the screws with the caps. If you print it in one color, the covers are almost unnoticeable.
Important! The screws can rust so I would advise to cover them in silicone or hot glue before putting the cap on.
You need to print 6 caps for the screws.
Best material is PETG or ABS, since PLA would deform over time under hot water.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
