Thingiverse
Knife Holder
von 3D_BetaPrinter
0
Downloads
2
Likes
0
Makes
This is my knife holder in order to organize my set of 12 knife.
Blade hole 2mm x 20mm
Print with 10% infill > 26h printing time
At least use 10% of infill in order to get a good stability
Blade hole 2mm x 20mm
Print with 10% infill > 26h printing time
At least use 10% of infill in order to get a good stability
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
