Thingiverse
Tools
Go to Model
Knife sharpener
223
Downloads
161
Likes
0
Makes
I really liked all the sharpening jigs out there.
I had just 1 major problem, non fitted for a standart 50X150 MM sharpening stone.
So here we go. Made this with bearing and smooth steelrods, to keep it as regid/precise as possible.
The planner board is angled at 17 degrees.
Layer height 02
Layer width 05
2 outlines
Infill 35 % grid
BOM.
1 x LM8UU
2 X 608RS bearings
2 X 20X3 mm screw
1 X 25x3 mm screw
3 X 3 mm nuts
3 X 20X3 mm round magnets
3 X 175X8 mm smooth rods (length doesn't matter just make sure the upper rod is long enough)
1 X 500X8 mm smooth rod
and of course a 50X150MM std grinding stone
If you like me design, please donate my next cup of coffee
https://www.paypal.me/rcmn
I had just 1 major problem, non fitted for a standart 50X150 MM sharpening stone.
So here we go. Made this with bearing and smooth steelrods, to keep it as regid/precise as possible.
The planner board is angled at 17 degrees.
Layer height 02
Layer width 05
2 outlines
Infill 35 % grid
BOM.
1 x LM8UU
2 X 608RS bearings
2 X 20X3 mm screw
1 X 25x3 mm screw
3 X 3 mm nuts
3 X 20X3 mm round magnets
3 X 175X8 mm smooth rods (length doesn't matter just make sure the upper rod is long enough)
1 X 500X8 mm smooth rod
and of course a 50X150MM std grinding stone
If you like me design, please donate my next cup of coffee
https://www.paypal.me/rcmn
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
