Knitted Dragon

Knitted Dragon  so this was a fairly lengthy build with the knitted texture. The head and wings print separately. and it is a large print. i can't guarantee the ball and socket joints if scaled down too far. The Wings... *Print with 3 walls* The wings print separately, mainly so there is not a flat surface and both side can have texture. They print in a small container which is pre supported. add a brim to the container and ensure you have good adhesion. I went through a lot of tests to get the right number of supports in the container that would allow it to be supported but also easy to break free. To break free just a gentle twist to break the supports. don't worry too much about trimming as they help with a little resistance in the socket. (if you print with 2 walls there is a potential for the wing to snap when removing for m the container) The Head... The head prints separately and attaches with a ball and socket joint. Be cautious when using mattes and silks as they te