Knitted Pumpkin Decoration #1

My wife wanted to buy some of the new fabric/knitted/crochet pumpkins to decorate our house, because Fall… 10-15 bucks for a small little pumpkin? Hold my beer! I have designed several decorative pumpkins which will apparently be taking residence on my living room mantle with Fall inspired miniature gnomes and fake flowers for the near foreseeable future. As you can likely tell, I am not able to contain all this fall excitement and wanted share these models with the community so you too can get in touch with your inner “basic white girl”, preferably while sipping on a pumpkin spice latte. This first design was printed in matte green Polymaker PLA with tuned settings for my X1C. I highly suggest you run your own calibration for your desired filament. The infill is set to lightening to help cut down on the print time as this is a decorative piece but any infill at your preference around 10-15% should be adequate. I printed at 0.12 layer height with a 0.4 mm nozzle on standard Bambu speed