Thingiverse
Electronics
Go to Model
Knob for potentiometer
11
Downloads
48
Likes
0
Makes
This is a remix. I took the original file and made the following changes:
- I reduced the diameter a bit and scaled it up in height. Useful for when there are a lot of knobs together.
- I reduced the inside diameter (Ø6 mm) to make it fit better on the potentiometer shaft.
- Added a position mark.
- I reduced the diameter a bit and scaled it up in height. Useful for when there are a lot of knobs together.
- I reduced the inside diameter (Ø6 mm) to make it fit better on the potentiometer shaft.
- Added a position mark.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
