Knucklebones Travel Board

DISCLAIMER: This board requires around 50-100 3x2 magnets, and 0.8mm dice. You can find both on amazon pretty easily, but will cost you around 25$ for both.

This board fits into the box in 6 different parts, which go on the sides of the box, and the dice go in the middle. Assembly should be pretty straightforward, just make sure you put the magnets in the right way, with superglue. The board needs to be printed very slowly and at 1mm MINIMUM if not, you wont get all the details. The box is ok at 2mm but 1.5 is better. The box is from some other models of mine, just with some extra pieces on the sides for the board. The other flat piece is to glue onto the top so it doesnt just shear off.

Have fun and feel free to post your model in the comments if you end up making it!