Koala Bear Hueforge

I used a variety of filaments because I'm a hobbyist and that's what I have on hand! 😂 I did print the calibration and I think it is fairly accurate, but your mileage may vary. This was created with copilot and hueforge. Hope it turns out well for you if you try it! Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmFilaments Used: PLA Spool3D Black Transmission Distance: 2 PLA M3D Grey Transmission Distance: 2.5 PLA BambuLab Tough Silver Transmission Distance: 2.5 PLA Jayo White Transmission Distance: 10Swap Instructions: Start with Black At layer #7 (0.64mm) swap to Grey At layer #12 (1.04mm) swap to Silver At layer #18 (1.52mm) swap to White for the rest. I printed it with a brim, but that shouldn't be necessary. Some other hueforge prints I've tried have curled up at the edges, though. So I figured better safe than sorry.