Kobalt Bin Divider Key

I have several of these Kobalt heavy duty storage bins. I wanted a better way to have a stable divider for them than just to jam a piece of loose plywood in channels. So I took basic measurements and design a key to fit in the divider channel allowing you to place a stable divider in the box to better utilize the space. The key is roughly 8 inches tall and 1 5/8" wide. The divider key still allows the boxes to lock together stack.

I used default, generic, settings for the filament out of Cura on my Anycubic Kobra Max. I positioned it flat across the print bed and did not need any support materials except for the magnet channels on the back side. I superglued magnets on the Bin Divider Key and then on the storage bin itself just to hold the keys in place when there wasn't a divider between them to hold them in place.

Print time each time I did it at 20% infill was 2hrs 15 minutes, again using generic settings(speed, feed & temps) from Cura.

I designed this in SketchUp from mea