Kobra s1 rear bed corner support

story time I struggled with this printer at first because i wanted a perfect first layer and it wasn't happening. i tried so much and for so long every minute of free time i had. the hotbed wasn't any more warped than my kobra 3s were. i eventually was about to give up and accept that my bed was warped. I was staring at my printer lost at what to do next when it was leveling and to my surprise it was actually moving my entire bed in the back corners as it probed the bed and it all made sense. so i created this support bracket. you will need -2x m4x25 screws -2x m4 washer and nut -2x m4x14 screws -a small amount of lock tight -i used a 4 way wrench common with rc parts. I'm sure they use them with other things (ill add a picture) i used cap head screws. you should be able to use any install the m4x14 in the outside holes and screw all the way through and back them out some, it will make it easier for later. swap out the rear bed screws to the m4x25s. line the bracket up under neath add your washer and nut with a dab of lock tight. tighten the corner screws until you feel some resistance (don't go crazy) please limit your z axis to 245mm to be safe. the bracket sticks out about 5mm more than it did with just the screws stock.