Kobra S1 Side Spool Holder

Spool Holder for Kobra S1 w/ PTFE Tube Guide Will allow for the spool to be relocated from the rear of the printer to the right hand side. Also includes a PTFE holder which allows for the filament to better flow into the PTFE tube without rubbing against the spool or corner of the holder. Model prints with tree supports which are easy to remove. I originally printed model with PETG for the increased strength. Installation Notes: The spool holder is installed using two of the existing screws on the rear of the machine. The holder has three holes but the middle hole is not used. Begin installing by removed the upper left screw, lining up the spool holder, and then replacing the screw. Then remove the screw that lines up with the most bottom hole of the spool holder and install the holder. Follow the same procedure for the PTFE tube holder, removing/installing one screw at a time.