Kobra X Bed Leveling Test 15min

One of the most common methods to verify whether the bed leveling is properly adjusted on the Anycubic Kobra X is by printing a specific test file designed for that purpose. In this case, a simple yet highly functional design was created to evaluate the uniformity of the first layer across the entire printable area. 🖨️ The design consists of a thin, flat base with approximately 0.2 mm height (a single layer), distributed strategically across multiple points of the print bed, including the center. This pattern allows you to clearly observe whether the nozzle is too close or too far from the surface in different areas of the bed. 📐 During the print, several important aspects can be analyzed: ✅ First layer adhesion – If the filament does not stick properly, the nozzle may be too high. ⚠️ Over-compression – If the filament looks overly squished or rough, the nozzle may be too low. 📏 Line consistency – Smooth, slightly flattened lines indicate proper leveling. 🔍 Differences between bed areas – If one area prints well and another does not, recalibration or adjustment of the auto-leveling system may be needed. On the Anycubic Kobra X, which features the LeviQ auto bed leveling system, this type of design is especially useful to confirm whether the sensor is correctly compensating for surface variations. Even with automatic leveling, small inconsistencies can still affect first-layer quality. ⚙️ After printing the test, it is recommended to visually inspect the result and, if necessary, fine-tune the Z-offset until the first layer appears uniform across the entire bed. When the lines are clean, well-adhered, and consistent, you can confidently conclude that the bed leveling is properly configured. 🎯 This type of test is quick, simple to print, and essential for ensuring higher-quality prints, preventing layer failures, and improving adhesion for larger models. 🚀