Kobra X - Camera Support

This works with both versions of the Cobra X: the early units and the later consumer release model Installation instructions for the consumer version of the Cobra X: 1- First, turn off the machine. 2- Then remove the screw on the side panel (photo) 4- Gently pry the panel open and remove the cover. 5- Carefully disconnect the camera cable. Next, gently lever the camera out of its original position. 6- Remove the three screws and release the cover (photo) 7-Cut a bit of the black tape that holds the cables together so you can free the camera cable a little more (photo) 8-Replace the cover and the three screws. 9-Place the camera in the new 3D-printed cover and connect the cable to the camera. 10-Once everything is done, carefully place the 3D-printed cover in position and you’re done (keep in mind that the print can be somewhat tricky; first make sure the camera works before installing the final piece, because if you try to remove the 3D-printed cover, its clips may break and you’ll have to print another one again) -------------------------------------------------------------- I designed this new camera mount because I wasn’t satisfied with the angle of the original one 📷✨ I recommend downloading the profiles since they are already painted 🎨, especially if you want to print it in color. Everything was printed using the Kobra X printer AI Functions This modification may affect AI-related features. Advantages: The spaghetti detection works perfectly ✅ Disadvantages: Foreign object detection does not work properly with this setup ⚠️ 👍 Please consider giving a "Like" if you download the model — it helps me a lot! 📸 Share your prints so we can see your results! 我设计了这个新的相机支架，因为我不太喜欢原始支架的角度 📷✨ 我建议下载这些配置文件，因为它们已经上好颜色了 🎨，如果你想彩色打印会很方便。 所有部件都是用 Kobra X 打印机完成的 AI 功能 此修改可能会影响 AI 功能。 优点： 意大利面检测功能运行非常完美 ✅ 缺点： 异物检测在这个修改后无法正常工作 ⚠️ 👍 如果你下载了模型，请点个“赞”，这对我帮助很大！ 📸 欢迎分享你的打印成果，让大家一起看看！