Kobra X Gantry Lighting

Add lighting to your project on your Kobra X printer. Version 2 note. Added a little extra clearance for printhead variations. ~ Thanks Christian Uses standard 8mm COB and FCOB lighting. Can be powered of the Kobra USB port or any USB wall adapter or computer. You will need a USB cable extension in whatever length you desire to get to your choice of power source. The USB cable routes nicely down the loom on right side. If you are going to run direct off the Kobra USB, there is Amazon link below. Requires four M3 x 30mm fasteners. Parts: Light USB powered USB extension cable (if you are running to Kobra USB port) M3 Hardware kit if you do not have the fasteners Clear PLA Filament for diffuser The main bar is dovetailed in the center to join the sides. Add a drop of superglue is recommended. This is a diffused version which spreads light more evenly but requires you to print with clear filament available here. The included models are set to two color printing so you can print in your color of choice and the diffusers section just where needed. As a bonus the lightbar mounts cover the ugly extrusions that come on the Kobra X Click to visit Raccoon Engineering