Thingiverse
Kodama Trinus Community LCD Case
by cdashdashb
2
Downloads
1
Likes
0
Makes
A case for the community programmed Nextion display for the Kodama Trinus 3d Printer, if you want to make one read this forum post: https://www.kodamaforums.com/phpBB3/viewtopic.php?f=17&t=1920&sid=eff8ae7c7701d98a6f53b0aa71d939be&start=190.
The angled mount is designed to be mounted to the right Z Rail.
I later intend on making another mount that will work in other locations.
Hardware required:
6X M3 screws to hold the front on, longer than 13mm and they'll stick out the back
The head should be roughly 6mm to fit in the recessed holes
Two of those simply hold the mount to the display case
2X M3 screws that are 20mm long, with matching nuts to hold the mount onto the Z rail
Update: Created a mount for the Trinus Enclosure that fits on the curved surface, some form of double-sided foam tape or adhesive will be needed for that, I also put cap screw holes that match perfectly but connecting the mount to the case still requires some form of adhesive at this point.
M
The angled mount is designed to be mounted to the right Z Rail.
I later intend on making another mount that will work in other locations.
Hardware required:
6X M3 screws to hold the front on, longer than 13mm and they'll stick out the back
The head should be roughly 6mm to fit in the recessed holes
Two of those simply hold the mount to the display case
2X M3 screws that are 20mm long, with matching nuts to hold the mount onto the Z rail
Update: Created a mount for the Trinus Enclosure that fits on the curved surface, some form of double-sided foam tape or adhesive will be needed for that, I also put cap screw holes that match perfectly but connecting the mount to the case still requires some form of adhesive at this point.
M
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
