KOENIGSEGG JESKO

The Koenigsegg Jesko!Please follow the 3mf file settings when printing, they are carefully thought out and tested. That ensures good quality. Please remove the supports carefully and calmly. The spoiler or the side mirrors might get damaged otherwise. ASSEMBLY:The tires are very tight, so you need to apply some pressure. Easiest way is to add tires to both sides at the same time, and one finger to both, and squeeze. They should just snap on if you're using the right amount of force. The tires being separate of course adds the possibility to print them as different colors! PRINTING:If you print via the STL file, you should follow these instructions:Only PLA is a tested to work material: Others might work and probably do, but I make no promises.Make sure that your slicer creates supports for the axles for each wheel.Use slow overhang speeds.Use tree support style.15% infill is excessive, use 5-10%.Layer height 0.08mm (or even smaller). Please make sure your bed is clean so the print