Kohler Command CH series pod filter adapter

**if STL loads in super small, scale it up 2540%, my cad software does not always play nice for some reason**

Pod filter adapter for the carbs found on Kohler CH series engines, should work for accelerator pump or non accelerator pump carbs. Pictured it is on a CH20S engine. Designed to work with a 2" mount UNI dual element pod filter. This adapter also raises the bowl vents a good amount to prevent fuel from splashing out of the bowl vents and flooding your engine during rough offroad use.

I honestly don't know what material is best for this. It's at your discretion to decide what is best for occasional contact with petroleum products. PLA+ has worked for me so far

Make sure you get all the supports out of the little vent tubes, i found you can push them out with a small allen wrench or piece of wire.

A short video of it: https://www.youtube.com/watch?v=3qImXTvDZKw