Koi Fish Stamp

Proof of concept for a custom silicone stamp. The model is a two-part mold to cast a silicone stamp, as well as a holder for the stamp. The stamp had a raised edge and should fit in the holder without any need for adhesive. InstructionsMix 2 part silicone according to instructions. I used a very low durometer silicone so it was pretty soft, but this would likely work with anything under 60A or so. This one on amazon is similar to the one I used: https://a.co/d/cdQ1AqdPour silicone into the bottom mold (the one with the fish) just until it gets to the beveled edge. If you overfill it it will leak everywhere in the next step so try to avoid that.Place the top part of the mold… on top. The well in the center should catch most of the squeeze-out but some may escape on the sides. Should be easy to clean up once it's cured.Tape or clamp the mold together to ensure a tight fit. Or put something heavy on top.Allow the silicone to cure per manufacturer's instructions.Cut away the excess