MakerWorld
PrintMon Maker
Go to Model
Kona Ice Man
6
Downloads
8
Likes
0
Makes
This is a super cute little figure of the Kona Ice Man/Penguin. This print does take a lot a filament because of switches between colors so often. I also though it was worth noting that the support under the right arm did fall off during the print, although it ended up turning out fine. I'm not sure why this happened, but be on the lookout for that.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
