Konica C35 replacement crank handle

A replacement crank handle for the Konica C35 Camera. You will need a thin metal pin about 0.8mm in diameter and about 6.5mm long. Can be cut from a paper clip.Unscrew the remains of the mechanism from the camera's inside. Be careful not to loose the washers and coil spring. Set them aside.Remove the top nut and flat spring from the top plastic casing.Insert the printed part through the top and slide the metal pin in to lock it in place.Push this assembly firmly inside into the hinge and add the flat spring back followed by the washer.Screw this back into the camera's body. Feel free to remix or adjust. This was done in a hurry using FreeCAD for a Repair-Coffee workshop. There are certainly improvements to be made around the hinge to take advantage of the flat spring's action when folded in or out.