Koozie - Simple Sleeve

Went on a koozie binge and this was the first of the few. It features 4 finger grooves around it, a snug fit to Pepsi cans and Coke cans (I imagine others too!), and a hole in the bottom.

I printed mine with PLA and used a 1mm wall thickness, with 4% gyroid infill to have the most air on the inside for insulation. The bottom layer count was increased to be 6mm thick of solid filament to give it extreme stability.

Not much else to say about it, it's a koozie to keep your drinks colder for longer and to maybe strike up a conversation about 3D printing while doing it.

It is a single model, single file, and an easy print to perform. Functional right off the print bed!

If you're curious about the performance of the koozie compared to ‘Off The Shelf’ Koozies, check out the video below where I actually compare them:

https://youtu.be/R0ECVi3uI0k

If you like what you see on YouTube please like and subscribe! Check out the other 3D printing videos I have as well as the other mo