Kossel Pro/mini Delta E3D V6 End Effector Version 5

Also Fits Kossel Mini

This is another attempt at making an end effector for the kossel pro and e3d v6 hotend. It is a direct replacement for the stock end effector. Arm spacing and radius are the same as stock. My previous few have cooled off the heater block too fast and this one does not.

Another goal of this design was to limit the interference between the fans and the arms, so i've put the fans in the center and reduced the part cooling fans from 3 to 2. A new duct system puts the air flow closer to the nozzle, which will hopefully improve PLA prints greatly. It mounts to the bottom with 3 #4 screws.

Other minor improvements include a cable tie mount for clean cable routing and a single bolt hot end clamp to reduce the bulk and number of parts needed. Single layer tabs aid in bed adhesion for small surface area sections.

see the older version 3: http://www.thingiverse.com/thing:1765913

Parts List:
E3d V6 Hotend
3x 30x30x10mm fans 24V or 12V depending on your print