Thingiverse
Kossel PSU standoff (Folger Tech. and compatible)
von docpayce
76
Downloads
35
Likes
0
Makes
Good: Since I upgraded my Kossel to longer magnetic rods, I got an effective printintg diameter of 200 mm. :D
Bad: That diameter is so big, that now one of the cooling fans hits the PSU. :P
Solution: Standoffs for the PSU. It pushes the PSU out of the way by 40 mm. Built pretty sturdy.
Needs: 8x M4x12 screws, 4x M4 T-Nuts for both sides.
Bad: That diameter is so big, that now one of the cooling fans hits the PSU. :P
Solution: Standoffs for the PSU. It pushes the PSU out of the way by 40 mm. Built pretty sturdy.
Needs: 8x M4x12 screws, 4x M4 T-Nuts for both sides.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!