KP5L_Spool_Holder

I designed this spool holder for my KP5L with the intention of providing a more stable flow of filament because I had some jamming problems. It's not my best design, but it does its job perfectly. I hope it helps you, and you can print it without problems.

I used PLA, but I recommend using PETG since it is more resistant. Print settings are flexible and depend on each user and printer, I used the following:

Supports: NO
Resolution: 0.20
Nozzle: 0.40
Bed temperature: 60
Printing temperature: 220
Print speed: 40mms
Filling: 15%

Thank you all and I hope it is helpful to many. If you share, I would greatly appreciate it.