Thingiverse
Electronics
Go to Model
KryoFlux - single floppy case
138
Downloads
123
Likes
8
Makes
This is my second type of Kryoflux case, this time just for single 3.5 floppy drive.
I tried to make it look like Atari 1050 floppy drive, so it is more focused to appearance than ease of assembly.
- Dimensions of the largest part are: 163x113x32 (LxWxH).
- You will need 12V 2A power brick with center positive 5,5/2,1 barrel connector.
- The TVS and fuse is just an easy to make overvoltage and reverse polarity protection, not a 100% solution.
- Unfortunately the instructions on how to put it all together got lost somehow and I have no time to recreate them. So I apologize for that and I hope you can figure it out from the pictures.
I tried to make it look like Atari 1050 floppy drive, so it is more focused to appearance than ease of assembly.
- Dimensions of the largest part are: 163x113x32 (LxWxH).
- You will need 12V 2A power brick with center positive 5,5/2,1 barrel connector.
- The TVS and fuse is just an easy to make overvoltage and reverse polarity protection, not a 100% solution.
- Unfortunately the instructions on how to put it all together got lost somehow and I have no time to recreate them. So I apologize for that and I hope you can figure it out from the pictures.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
